Find content
I can't open it back up for some internal shots because the wiring job was pretty tight (I didn't have any spare wire lying around so I had to use what was already in the gun), but I'll entertain questions if you have them
puky
Member Since 11 Dec 2006Offline Last Active Feb 07 2010 01:35 AM
Posts I've Made
In Topic: An Actual "nite Finder" Mod
16 December 2009 - 12:11 AM
I did something similar to SpectreX but wanted to go for a one-hand friendly design. So I put the toggle on the side so I could flick it on or off with my index finger. The position is great but I had to do a number on the toggle switch in order to get it to fit.
I can't open it back up for some internal shots because the wiring job was pretty tight (I didn't have any spare wire lying around so I had to use what was already in the gun), but I'll entertain questions if you have them
I can't open it back up for some internal shots because the wiring job was pretty tight (I didn't have any spare wire lying around so I had to use what was already in the gun), but I'll entertain questions if you have them
In Topic: Heeelp!
21 November 2009 - 08:44 PM
Whisper101, on Nov 21 2009, 05:29 PM, said:
puky, on Nov 21 2009, 05:19 PM, said:
My guess is there's an air leak somewhere..
I though that that might be the case but i cannot figure out where! I plugged the random hole in the bolt... Where else could air leak out of?
The plunger head I'd think, it looks kind of fuzzy in the picture you posted. That might just be because of the focus of the camera, but it looks almost felt-esque to me, which would cause huge air leakage. can we get a couple shots of your plunger setup?
