neodore

Sorry about the picture I dont have a camera except for the one on my phone.

tomorrowsDarkness, on Jul 16 2010, 04:47 PM, said:

This may be a dumb reply, but have you tried changing the batteries?

Yes I have, but the ladyfriend is still unhappy.

As for the vulcan, The batteries I'm using are the same ones out of my other vulcan which shoots perfectly fine for a stocker.

All the parts are still working and rotating as they should be but it just won't push the dart out on full auto, I might just try to find some silicone and see if I can extend the seal further forward as It looks like it may not be sealing properly

pjotrkuh, on Jul 15 2010, 06:54 AM, said:

Did you drill it out or just removed the restrictor?

When the vulcan primes/ is primed the plungertube comes foreward and seals against the chainlink, in that piece of plungertube is a grey O-ring for optimal seal....

If the barrel does not come foreward or doesn't stay foreward there is something wrong with the internals....

In the case of the plungertube not staying in the "sealed" position when primed, the plungertube has been replaced wrong, on the plungertube there is a little square(?) nub wich must be faced towards the shell, because another orange (the color could be different) nub needs to "catch" and hold it until the dart is fired.

Q:Did I drill the AR out?

A:Yes I did drill it out but the grey O-ring is still in place without even a mark on it.


Q: Did I muck up the internals?

A: As far as I can tell i haven't. I pulled the internals out of the gun so I could check the movements but as far as I can tell it is all moving as it should.

---EDIT---

As far as I can tell it all works as it should. If I forceably hold the belt up to the tube and manually cock it, It fires really well but in the gun and on auto it dosn't seam to work at all.