Green Wing

 IMG_1184.jpg   96.8KB   130 downloads

 IMG_0932.jpg   143.71KB   120 downloads

Writeup: http://nerfhaven.com...tank-internals/

Nope I use a 90 degree elbow cut in half to make two Wyes. http://nerfhaven.com...a-homemade-wye/

If you had a scrollsaw you could have used that, but, it came out well in the end. Also, where is polycarb found, cus I have looked everywhere and asked everyone, and I still can't find it. Also I can't find a 1/2 inch wye. I probably will just order it when I get the money necessary for buying them. 

 

-Montymarks

 You can get polycarb off of Mcmaster. You can also make a wye using a PVC Tee and a 90 degree elbow.

I really like the barrel selector mechanism. Very clever. 

 

Out of curiosity, what's your rate of fire with the big blast tank and the HPA system?

Takes about half a second for the tank to fill each shot to max power. Can be faster with a better HPA setup with a higher fill rate.

 IMG_0884.jpg   103.86KB   147 downloads

 IMG_0880.jpg   60.42KB   151 downloads

 IMG_0362.jpg   116.74KB   151 downloads

Overview and firing: https://www.youtube....h?v=zJN2o4IME98

Full imgur album: http://imgur.com/a/OV0yp

X2 Hopper HPA blaster. Super soaker Shot Blast shell. I cut open the water reservoir and made screw ports. The inside is a 1st gen big blast with my X2 hopper system. The blaster is single fire and you switch between barrels with the polycab slide. This allows you to still be able to fire while reloading one hopper. 

The dart doors are magnetized.