Petrie

I noticed that on the Spudfiles site(http://www.spudfiles.com/) they have a Spud Wiki. It is like a link to Wikipedia but it is seperate from the mainwiki site. On the spud wiki they have tons of definitions and abbreavations that is hevan for a noob. I found it extreamly informative and made me not sound like an idoit when posting on spudfiles. It would definatly be somthing for the adamin or mod or whomever to cheak out. Imagine a NerfHaven with out posts about what an air restrictor is and what is this gun questions. Also any Haven member would be able to add content to the wiki.

spudwiki: http://www.spudfiles...title=Main_Page

Any comments would much appricated

Thanks

~Petrie

I got open my magstrike today so tell me what you think

Whats your opinion on the new guns?

i was wondering how much a sprinkler valve like the one used by CX in the mod section wouls cost and wher i could get one.
any other little sprinkler vavle comments/warnings would be much appricated

thanks
-Petrie

The other day I was looking up how to make a spud gun on howstuffworks.com and figured I could use those same concepts to make a combustion powered. (kinda like boltsnipers combustion gun)

The cb-1 is baisicaly a 6 inch piece of 1/2" pvc with one end plugged by a rubber stopper with a butan valve and a grill lighter epoxyed on. I also put on a coupler and some 19/32" brass to shoot micros.

the ranges are about 65-70 feet that i measured with a 25' tape measure end to end

real bad picture I know


The major draw-back is that it takes about 25-30 minutes for the fumes to accumulate. That is way too slow of a ROF.I have tried all kinds of fuel but they all seem to take a while to get to the point where it can be lit.
any suggestions?