LittleB

A question for anyone who does own a LS, can the extended barrel on the pistol be removed? Also, what is the greatest OD of the barrel? Is it possible to remove the barrel and replace it with pvc with brass or 1/2" cpvc inside?

If you dissasemble the front blaster the barrel slides right out. The orange suports the barrel sits on are glued to one side of the front blaster. From within the larger blaster if you look at the front of it, there is that big orange adapter that slides inside the front blaster; right behind that is a short length of barrel (4-5inches) that comes right out. This piece is completely seperate from the "staging area" where the dart sits after the blaster is cocked. The outter diameter of the barrel itself is 3/4"; all you would need to do for a barrel mod would be to removed that barrel and dremel off the small lip on the large adapter piece.

Also I've noticed ranges that were posted for the longshot with the added BBB spring were between 60-99 feet.
The range for the longshot with air restrictors removed, a stretched longshot spring (stretched around 3 inches longer) and stock steamlined darts is ~42feet flat and ~62feet angled 30-degrees. This was tested on flat ground between two houses that share one long driveway, wind at 0-5mph.

Happy Modding
-LittleB

I just tested the ranges of the banding mod for the DTG. I used 3 bands and fired from the countertop in the kitchen down the hall (note: both DTG handles were touching the counter top.) The flat ranges were ~49 feet for a dart tag dart and ~53 feet for a stefan.
I also took the DTG and added a stock made of 1 inch diameter pvc, It makes the gun feel so much better when holding it.

It is held on by wraping the pvc inside the gun in duct tape so it creates a tight fit and then wrapping the outside in duct tape to add stability; The stock does not move around at all.

-Little B

For those who were wondering what the LongShot would look like without the front pistol; I also Photochopped out the scope and bi-pod.

This gun is the greatest thing I've ever seen...ever.

The valve has not been plugged, it all has to do with how many ml/second the gun can put out. Go to isoaker.com's armoury to find out more.

Actually, I modded one of mine (CPS 120) and did get but 80 feet with 150 pumps. So I scrapped the valve and pump.

I also have a modded Super Soaker, the CPS 2700 Cut the nozzle off and shove 1/2" sch 40 PVC down the barrel (fits perfectly). 23 pumps with stock micros = 116ft flat, 160ft angled at 45 degrees.