ZACHARIAH

As for funneling. I think I'm the only one that actually does that. But I've found that it is a simple and effective mod. It gives a much smoother transition into the barrel, reduces the turbulence at that point as it does not create any backpressure. And it makes it that much easier to load a dart. It I think is a very important step when doing the RSCB because it also helps direct the dart.

I do this as well. I go as far as actually funneling the PVC in addition to the barrel material. In the below pic, the PVC was funneled by twisting wire cutters into the end (the sides are sharp enough to shave the PVC) and the brass was flared with the same thing except it more bent the brass then removed material.

I've never used an RSCB without a barrel like this, so I'm not sure how much it helps. All I know is that my RSCB's rarely jam.

Sweet! All I have to do is go to Home Depot and find my dad's wire cutters. I am not gonna be able to get the stuff for a while because today I start school.

BlackSunshine, I did not funnel out the petg, I was gonna get a ball valve but my mom didn't let me go the the hardware store. I reanforced (SP?) my trigger. What do you mean 1/2" reducer?

Pumping seven times won't even engage my OPRV. Maybe your pump count is the problem. Also, BBBB's have terrible o-rings. You have to pump them more than if the seal was normal.

I have two and a half wraps of e-tape and it engages the OVPR on mine. I don't like to pump it ten times because the last time the endcap flew and hit my eye. It was pretty funny, but hurt a little.

ok. Time for some more fact finding.

1. What is the lenght of the rear part of the rscb? What material are you using?
2. what is the lenght of the actual barrel itself. (the front peice)
3. how many times are you pumping and are you consistant with that # with each shot?
4. Rather then a target that is only 40% of your maximum expected range How much difference is there when the darts are allowed to fly their full distance? I would expect gradual decreases in range as you cycle thru the clip.


And yes a picture might help.

I am using pvc, the rear part is six in., the barrel is twelve in., I am pumping it seven times, the shot is pretty consistent, the first dart will shoot at shoulder level.

Have you posted this somewhere before? I'm getting a sense of Dejavu. (and not the club)

Gonna need more info then this. Are all your shots crappy? What are you using for barrel material?

Got any pics of the setup?

With the mag full the dart shoots at shoulder level. My barrel material is OMC thickwall petg. I have some pics on my bbbb if that will help. Also I don't think I have posted this before.