http://i626.photobuc.../Picture083.jpg
(3) On the grip on top drill a hole right behind the the protrusion that stops the attatchment from sliding off.
http://i626.photobuc.../Picture084.jpg
Like so
(4) Remove the same protrusion on the bottom of the barrel extention. then unwind a wire hanger and stick it through the holes you made (5) twist the two ends together like you would a twist tie (6) Bend towards the hanger then duct tape the twist so you don't cut yourself on it.
http://i626.photobuc.../Picture085.jpg
The finished product should look like this
http://i626.photobuc.../Picture077.jpg
I added better quality pics
P.S. This is my first write-up so sorry if it is bad

P.S.S Srry for poor quality pics
Edited by from russia with nerf, 02 May 2009 - 10:20 AM.