6 replies to this topic

[g-force]

The point of this mod was to fix my first mods biggest problem, low rate of fire. To do this I used:
16/32 brass
1/2 aluminum
sealent (hotglue, plumbers goop, etc.)
Spy gear signal launcher
Step 1: Cut your stock barrel here

Step 2: cut yourself four 8 inch segments of aluminum and one 3-4 inch lenght of 16/32 brass.

Step 3: Cut your 2k turret 2 inches shorter.
Step 4: Drill holes just big enough to fit a dart into behind each barrel in the turret.
Step 5: put circles of hot glue or plumbers goop around the alluminum tubing and jam it into the turret

Step 6: Take your 16/32 brass and slide it over the circle on the back of the the turret behind where the barrel being fired would be.

Step 7: Put several hot glue or plumbers goop circles around the brass and slide it into the stock barrel.
The finished product will look like this:

Ranges are still the same, 120 feet but it is no longer silent.

[Quilan Fett]

16/32" brass = 1/2" brass.

[g-force]

16/32" brass = 1/2" brass.

Well, ok.

I just changed the aluminum barrels to PETG,
To do so just chop the alluminum down to 2 inches and hammer the petg on it is so tight there is no need to seal it that is already done. just put some duct tape on to straighten the barrels and make it look cooler.

Edited by g-force, 20 April 2008 - 02:15 PM.

[CaptainSlug]

Don't you mean 17/32" brass? I've never seen any darts that fit in 1/2" aluminum tube. The aluminum tube I use for barrels has an ID of .527" and an OD of 5/8".

Also your cuts look terrible. You should use a pipe cutter or consider buying some form of power tool or mitre box.

Edited by CaptainSlug, 19 April 2008 - 07:37 PM.

[g-force]

Thanks for the tip I used a hack saw. If you didn't see my new pic that was exactly why i changed the barrel to PETG and i now get even better results.

Edited by g-force, 19 April 2008 - 08:21 PM.

[Cannonball]

Nice job with the turret g-force. I like the idea though. If I may suggest though, It'd look better if you cut the existing red barrel shorter and attached the turret closer to blast chamber. It'd look alot nicer and I imagine it'd be easier to use. It all comes down to person preference though so if that works for you...

[g-force]

Thank you. i will try that soon although I am waiting to see how your idea for this gun will turn out.