BeastMode

Ok this involves multiple barrels, I know what your thinking this has already been done before. Well I didn't copy I got my sole idea from the Absolver scattergun by BendyStraw in 2008. My idea was to have instead of one screw on top that shot 7 darts, I would make different barrels for different situations.

What you need:
Nerf Titan
CPVC 3ft. just so you have enough.
Hot Glue Gun with Hot Glue
A dart you're willing to sacrifice for a good cause.
A swimming noodle with a 1/2in. hole in it that you are willing to sacrifice (you only need a little).
An Exacto knife/ scissors
1 PVC 1 1/2in. male adapter(the one with the out side threads).
At least 3 1 1/2in. female adapter(the other kind obviously).
Sharpie or other marker
Cutting Tool for CPVC and stuff like that.
Tape
Other stuff for the part I haven't gotten materials to make, I will post those materials on this at a later time
A brain that can process thought.


Part 1: Shotgun Attachment; since this is where my idea came to be here is the link.
Do that but don't do what he says about the Titan barrel.


Part 2: Rifle Attachment

Step One:
Take the swimming noodle and one of the female adapters cut the noodle so the part you cut off will be a little longer than the side opposite the threads in the female adapter.

Thats way longer then you should cut it sorry I was trying to make something else before hand so i just used that in the picture.

Step Two:
Turn the little piece of a noodle you have so it faces your working surface. Put your female adapter on it so you can look through it and see the hole in the noodle. Now center it use the marker and trace the outside of the female adapter on the noodle. Cut off the outside of the noodle and get it to fit inside the adapter.



Step Three:
Take out your CPVC. Stick it through the noodle, make sure the bottom touches the bottom of the noodle. Pull out your marker again and mark a length that feels good to you(this will be your rifle barrel). Cut it at the mark you made.


Step Four:
Put it together, but dont glue yet. put a little tape on it first and do a test fire but hold on to the barrel, and oh ya put on the adapter adapter.(Before you glue it it doesn't go far at all).



Step Five:
Warm up you hot glue gun cause it's gluing time. First glue the barrel in the little noodle thing. Second glue little bit of the noodle into the part of the female adapter that doesn't have the threads.
wait for it to dry. now you can put it on the male adapter and fire it.

Hope you enjoy so far please give me feedback and questions.
P.S. This is my first thread.