Jump to content


Liquideath

Member Since 01 Jan 2004
Offline Last Active Apr 04 2005 08:58 AM

Posts I've Made

In Topic: Fbr Trouble

13 August 2004 - 02:01 AM

You could also go with 5/8 fbr and Ĺ PVC, that usually works for me. It all depends on your materials though.

In Topic: Condensing The At2000

11 August 2004 - 11:22 PM

If you really want to condense an At2k you are going to have to extensively mod the case. What I did was cut the whole top off the case leaving only the pump holding section and the handle. In order for the gun to operate once you have done this you will have to tape/glue the pull valve directly on the pump. If you can do this there will be no reason to take off the gauge, you even could make it an air reservoir if you like.
Here are some pictures of my Air Tech 2000:
http://www.angelfire...nerf2/page5.htm

In Topic: Bolt Action With Ejecter

28 February 2004 - 06:32 PM

On the AirTech 2000 I just cut off the bulk of the case to make it smaller and look better. Then I just mounted the valve on the pump with epoxy and tape and put it back together. After it was all back together I telescoped some brass into PVC for the barrel. Oh and I almost forgot, I already had the pump plugged and the goo gauge made into an air reservoir. As for the Co2 hand gun I will put a movie up to show people how it works, but its just gravity fed bolt action like boltsnipers gun.

In Topic: Bolt Action With Ejecter

28 February 2004 - 06:06 PM

No, your pic didn't work Ironman.

In Topic: A Question About Dremels...

28 February 2004 - 03:39 PM

If you donít want your blades to wear out fast get fiberglass reinforced cut-off wheels. I have had my dremal since Christmas and i have only gone through one.