Jump to content

  2. → Viewing Profile: Posts: Broderick

Broderick

Member Since 29 Jun 2009
Offline Last Active Jul 17 2015 12:22 AM

Posts I've Made

In Topic: Effeminate 3.1

06 April 2012 - 01:07 AM

I'm a maybe. Not that I was any more certain May 19th. Let's move it to May 5th.

Same here. The 5th should work for me, but only time will tell.

In Topic: Effeminate 3.1

04 April 2012 - 11:11 PM

I'm going to try and make it out to this one, it's been too long since I nerfed haha. I just need to drum up a new primary and get things going! Hopefully +1 as well.

In Topic: How to make old pvc white?

05 February 2012 - 03:58 PM

Or you could buy it from Lowe's, their stores are very clean. The PVC is dusty sometimes but never discolored. I usually try to avoid Home Depot, but haven't been to Ace very often.

In Topic: Effeminate 2.4

02 September 2011 - 01:50 PM

Hey guys, I know I'm not coming to the war or anything but I'm gonna post a thread in trades soon with some of my guns up for grabs. Locals get priority, so PM me or something if you are interested in any guns. Some of the good ones are an At2k, SMDTG, and a Longshot all stock.
Make sure to take plenty of pictures at this war ;)

In Topic: The Two (or Three) Hour Homemade

24 August 2011 - 08:37 PM

The concentric circles idea is correct. The function of the O-ring is to reduce air leakage out the hole for the trigger, so that as much air as possible is used to propel the dart forwards (instead of leaking out around the trigger).

Something I found helpful in my build was rather than using an O-ring,get a rubber washer with the appropriate ID for your lag screw. It's just a different way of accomplishing the same thing, but it was a lot easier to glue since it has more surface area in contact with the Tee. It might have just been poor construction, but I get a better seal around my trigger as well.

  1. NerfHaven
  2. → Viewing Profile: Posts: Broderick
  3. Terms of Service and Privacy Policy
  4. Code of Conduct ·