MODcrazy

I would like to know what the best barreling material would be for streamlines for indoor wars. Thanks.

Hi guys, I got into Nerf last February and have really been into it since.
It didn't take me long before I got really interested in the older/vintage/rarer Nerf guns.
I have done a few modifications but have not posted any over here yet.
Seeing how I took some pictures along the way, I decided to do a write-up to contribute a little to the NIC.
This write-up will (hopefully) guide you in making your own Nerf SuperMAXX 1000.

**This idea is not entirely new. Credit goes out to NerfRogue83 for his furyfire write-up and jerm781 for helping me as well as his own write-up.

Things you will need:
1) Nerf Furyfire
2) Nerf Air Tech 2000 internals
3) Your assortment of glue (I used fishin’ glue, plumbers’ goop and hot glue in total)
4) Vinyl tubing, I'm not sure of the sizing I used
5) Rubber washer(s)
6) PETG or barrel material of your choice
7) Dremel
8) Hacksaw
9) E-tape

========================================================================


And let’s begin!

Part 1:

Take out your Furyfire and open her up.
Sorry do not have a pic here. (But you do not really need reference as you will be removing most of the internals).
Remove all internals.

Next, we will be working on the turret.
Cut along here, I used a hacksaw.
** Make sure you do not cut away the 3 prongs.



You should get something like this.



Take out your dremel and widen the holes at the back till it is as big as the inner diameter. (or till your darts can fit)



Once done, it should look like this:



Next, align your turret in place and yes, if you did not already guess this, we are going to make it rear-load!
Take your marker and drop it down 2 of the barrels, the same way Angel did for his Doomsayer.
After that, drill through to make rear-loading holes. (I used a dremel)
My holes are pretty small and not aligned perfectly as I wanted to make it as clean as possible. You can drill bigger holes if you want to.


Get your barrel material and cut 8x3'' of it. I used OMC thick wall PETG.
Once done, paint your turret.
After it has dried, wrap E-tape around your PETG till it fits snug in the turret.
Goop it in.



Next step is to increase your pump stroke.
First, begin to shave done the ridges on your FF pump.
Then widen the orange hole in your turret till your pump can move through freely and smoothly.
Here are pictures for reference:




Now, get your at2k and remove its internals.
Remove goo gauge and re-connect the tank to the pump using vinyl tubing.
Shorten the pump tube, mine is 9.2cm.


Plug your pump.


I also wrapped a round of E-tape underneath the O-ring.
Remember to lube her up!



Cut here and here.


*DO NOT GLUE THEM TOGETHER YET


(Picture Limit, Part 2 below)

Oh my god! That is beast! I wish i had an air tech 2k to use for this mod.

sry about my grammer and copper it what i use for my RSCBs! its way to loose

r fishing weight stefans banned from this war

i dont know but thats pretty weird