Jump to content


nerkum

Member Since 23 Dec 2008
Offline Last Active Nov 27 2016 04:15 PM

Posts I've Made

In Topic: RADS-12 review and modding analysis

21 July 2011 - 07:41 PM

I like it, but I don't see an easy way to make it rear loading. It is possible, I can see it being modded to work with a quadshot. Which would be really nice.

In Topic: Marshmallow Mforcer

03 June 2011 - 12:25 AM

To reattach the screw on turret cap I actually left a couple of barrels unattached, then screwed it on snug and reattached the barrels.

I never had to take those screws out, basically only the cover, front piece, and hose was modified. No need to play with the piston.

You do not need to worry about the hose unless you want to do more then 25ish pumps. Otherwise you will need to replace it.

In Topic: LED stefans?

19 April 2011 - 01:39 PM

The Lithium CR1025 battery is one of the smallest 3v batteries. It is a little bit heavier then a washer and when you add in the LED it does make it a tad heavy. Using a low power blaster probably won't hurt anyone, but the target cannot see the dart light, it is good for tracers. I have already done this, and cost is about 50 cents per dart to do this mod not counting foam. Plus the connection to the battery usually breaks when it hits.

In Topic: My Nerf Salvofly

20 February 2011 - 10:57 PM

Good job with the valve, looks like you are rocking it now.

In Topic: The Semiauto Salvo

10 February 2011 - 08:06 PM

Look into directional control valves. Clippard makes some good and cheap ones. They cut off and vent in the same motion, eliminating the need for several valves.


Just made a video of the Clippard Valve. I used the MAVO-3P in this video. It is a three way valve, normally open.