ToadBrews

I am looking for a good way to carry 12 round rival magazine on a battle belt or plate carrier. I don't want to spend $15 on a 3d printed holder for 1-2 mags. I was using these:

https://www.amazon.c...ht holder&psc=1

Which are fine for carrying a few magazines, but I want to carry about a dozen and 12 flashlight holders would use my entire battle belt. What I'm hoping exists is something that will hold 5-6 magazine arranged vertically and only use up 2-3 molle loops. I own a variety of dump pouches/holsters/admin pouches etc and none of them are quite right (they're mostly not tall enough).

What do you guys use to carry rival magazines? I'm open to pretty much any suggestions that will let me carry 10-12 magazines and cost less than $40 total. That can be one big pouch, two small ones, a thigh rig, whatever. I just need it to not take up a ton of real estate since I need to carry other gear as well.

https://www.amazon.c...val 40 magazine

And they're actually reasonably priced! Look to not quite be in stock yet.

I have a couple of persuaders, and ergonomically I prefer them to the hammershot or the strongarm. I would like to make them a little more powerful, but I haven't been able to find much information on modding them, neither here nor elsewhere. I definitely want to at least upgrade the springs. So my primary question is, will they take the worker 8kg Hammershot spring? If so, is that too powerful for the smart AR? If they won't take that spring, is there a readily available spring that will fit them? Thanks in advance.