kwaneazy

Hi Everyone,

Again, apologies for the double post but I have made some progress in the problem.

I have discovered that the tank pin opens the same amount regardless of what pressure there is, but at higher pressures, the tank pin needs to travel further back to release all of the air.

For instance, if the trigger pulls the tank pin back 10mm to release the air normally, at higher pressures, the trigger needs to pull back 15mm to release all the air.

I have played around with adjusting the trigger to try produce more pull on the pin but there is only so much room I can mess around with.

There is obviously something going on inside the air tank but I am hesitant to open it up. Has anyone opened a titan tank before for repairs?

Lt. Stefan - ... Then I hope that's not the case.

TantumBull - Cheers mate I'll try find his post. But you're right it is a matter of release and NOT actually holding the air. I think whatever I pump stays in the tank, but at higher pressures it doesn't release as it should.

Gonna break the beast open again today and hopefully make some progress.

Thanks for all the help guys.

Sorry for the double post but just thought I'd update everyone on the problem solving progress.

I've opened up the Titan and taken out the two ball bearings, as well as plugged up the over pressure valve with hot glue.

When I put the gun back together I was able to pump it 22 times and it fired beautifully. My excitement, however, was short lived, and subsequent attempts at pumping it more than 9 times have failed.

Lt. Stefan - I plan on reopening and checking the tank pin opening. If I find that it doesn't open as much with more pumps what should I do?

Thanks for the replies guys.

I live in Australia and had this shipped over from Canada from an ebay purchase.

I was going to open it up and do the standard mods anyway so if this thing can be remedied by taking out the tilt balls I'll give it a crack.

I'll see how I go.

This thing shoots everything under the sun!

Bravo.