Jump to content


Kilomona

Member Since 22 Nov 2015
Offline Last Active Jun 05 2017 06:54 AM

Posts I've Made

In Topic: 95 Crossbow Clip Fed?

28 February 2017 - 03:42 PM

Similar to how the koosh vortex tornado used a priming handle that pulls the rod back, but isn't attached so it can for forward again could we put a long notch on the priming rod?

In Topic: S.O.S. Endangered Shell Protection Initiative

20 February 2017 - 03:09 PM

The idea of this thread is what we're working on over in the "koosh vortex tornado scans (now a shell replication thread)" thread.

In Topic: Can everyone please mesure their nerf guns?

16 February 2017 - 08:16 AM

Sure, once I'm home on Friday/Saturday. Will upload data in centimeters and inches. Might be off by a little bit because I don't have calipers, so I'm using a tape measure.

In Topic: Koosh Vortex Tornado Scans (Now a shell replica concept thread)

06 February 2017 - 08:26 PM

DON'T QUOTE THE PICTURES IF THEY'RE IN THE POST IMMEDIATELY ABOVE YOU, YOU DUMMY.

- ICE NINE



That is niiiice. Is it 3D printed? And do you have internals to put into it to test the strength? I don't think it won't matter as much for the tornado, as the internal parts take most of the stress, but it would be nice to see some good progress.


In Topic: Koosh Vortex Tornado Scans (Now a shell replica concept thread)

31 January 2017 - 05:23 PM

As for the aluminum casting, what about modeling shells in foam? We could experiment with small, less detailed shells like the SSPB, or print shells in flammable filaments ( if such a thing exists).