OceanSkais

Unless you upgrade the batteries, no

Hi, I've been searching for a thread on this, but I can't seem to find much detail on this topic anywhere. I've been eyeing a lot of really good looking paint jobs with nicely detailed logos, and I'm wondering how people get them looking so sharp. I've seen some great guides on painting in general, and some assorted specifics, but nothing about logo/hand detailing in particular. Can anyone point me in the right direction?

Its because they use really small brushes and go realitvely slow. The quality or the brush and the paint great effect the outcome aswell.

Drill out the ar then knock the remainders out with a hammer/screwdriver. That will allow the dart to go farther back in the barrel which means less resistance for the dart tooth

Are those ranges angled cause I seriously doubt that your hitting 130 and also this should be in the modification pictures thread due to the fact that this isn't really a write up.I would love a write up of this blaster if it really does hit that hard.

I didnt do a write up because theres not much to it. I basically cut 2 lengths of cpvc and put a coupler in the pho barrel. Also it does hit those ranges but their tested with elites. I did try some modified ones and uber domes and they all hit the same range. Im not sure its 130 (just an estimate) but its definitally over 110.

Hello NerfHaven

I recently purchased hobby boat motors from a local hobby shop.

Also, I would like to know if I could run one stock motor and this upgraded motor. Would there still be performance increase? Thanks for answering my questions.

It would be an increase, but most likely either swerve up or down depending on which motor is stock and which is upgraded.