Jump to content


AwesomelyNerf

Member Since 23 Oct 2014
Offline Last Active Feb 09 2015 07:26 AM

Topics I've Started

Modified Sharpfire[And Guide]

15 December 2014 - 08:44 AM

Hi guys! This is my second mod guide,and I'm trying a different format. Text in the pictures. If you have feedback regarding this format,do tell me.
You can check out my overview video of this blaster here .


Mod at your own risk!

Posted Image
Internals Overview of the blaster. The trigger lock has already been taken out. It was originally located at the middle portion of the blaster.
Posted Image

After you have taken out the lock, you can take out the plunger assembly. This includes the plunger tube,breech, plunger head,and spring.

Posted Image
Posted Image
Replace the stock spring with a stronger spring. I used the Black Tactical v2 Retalitor spring.
Posted Image
Posted Image
Posted Image
Posted Image
Posted Image
Posted Image
Posted Image
Posted Image
Posted Image
Posted Image

Hope you guys find this guide useful. If you have any questions,I'll try my best to answer them.

Flipfury Simple Mods

03 December 2014 - 05:31 AM

Here's my first mod 'guide',and also my first post on Nerf Haven. So I'm sorry if I miss out anything.But the mods done are very simple,and can be undone if you wish to.
If you prefer video guides,refer to this.


Posted Image

Posted Image
This was where the locks were.Remove the trigger,and then the locks.Once the locks have been removed,put the trigger back into place.
Do note that by removing the locks, you will be able to fire the blaster even when your barrels are not locked into place. Next image shows how the locks look like.
Posted Image

Posted Image
Next take the plunger rod out of the plunger tube. We will be doing the following mods...
-Seal Upgrade
-Dead Space Removal

To upgrade the seal, put a couple of rounds of teflon tape under your O-ring. For me,I just went with three rounds. You do not want your seal to be TOO good if you are running on a stock spring.
Next,dead space removal. Simply put hot glue into the empty space at the front of the plunger rod. Make sure that it's flat once dried.
Once you've done both of that,lubricate your plunger head with some grease.

Creating rear loading slots:
Posted Image
You'd probably want to this mod only if you're using stefans. Anyway, to create rear loading slots,simply use a pair of pliers and rip the dart post out of each dart chamber. After that, sand down the edges of the holes so that your darts do not get damaged.

Thats about it. For people who want to remove the hand guard(is that what you call it?), you can. It comes out as one piece and can be removed when the blaster is opened.

Hope this guide helps!Thanks for reading.