Jump to content

  2. → Viewing Profile: Posts: Blastershack

Blastershack

Member Since 13 Jan 2013
Offline Last Active Oct 24 2013 12:00 PM

Posts I've Made

In Topic: Longshot internal pump action mod (UPDATE)

06 September 2013 - 02:21 AM

This is brilliant! A clean looking pump grip and a use for the deploy! should one worry about the metal bar warping over time though?



I have used this with a 5kg spring and all is fine so far. But with my brass breech version with a 10kg spring the bar has had a little gusset brace More details comming later for that.

Alternate method: put the rod through where the bolt-sled attaches to the bolt. Reduces stress on the bolt-sled, might need a slight work-around for shell stuffs.



I really dont know why you would do that. As it wont reduce stress on the bolt sled only move it to a more vunrable place. Not to mention loads more shell work.
This is not really a viable option IMO.

In Topic: Long Strike Question

04 September 2013 - 03:30 AM

Yea they should just pop off good luck

In Topic: Long Strike Question

04 September 2013 - 03:26 AM

Try using a claw hammer or 2 small screw drivers to pry one side off. It should come off fairly easy.

In Topic: Modification and Paintjob Pictures

16 August 2013 - 05:09 AM

Posted Image

Doomsayer with venom internals
Rayven Rm2 motors full rewire
Rebelle guardian crossbow removed dart posts uprated spring and small paint job

Posted Image

Brass'ed breech longshot with internal pump action modification

Posted Image

In Topic: Problem with modding the Rapidstrike

22 July 2013 - 11:22 AM

Mine was also glued in the same location if you look closely you can see some indentations on the blaster on the outside. I used a 5mm drill bit and drilled to a depth of 10mm and it came apart quite nicely.

Again nothing to exciting but info none the less

  1. NerfHaven
  2. → Viewing Profile: Posts: Blastershack
  3. Terms of Service and Privacy Policy
  4. Code of Conduct ·