jumico

It's not rocket silence to get a barrel on there, but from my experience, the best way is you take the entire ring out of the middle so all you're left with is the outside ring. Then put your barrel all the way into it so its flush with the bottom and fill the gap between the barrel and the ring with whatever glue you'd like.

Thanks! I hadn't thought of this before but it makes a lot of sense. If the barrel is all the way in the ring it seems like it will hold together much better with glue.

Thanks to both of you for the help. I think I will experiment. I might try sanding down the cpvc so it can snap on like you suggested. I also might try filling the holes.

It seems weird that with the standard unmodified way the air must go through the three outside holes before going to the dart.

You can go over the developments in nerf in the Nerf Wiki. You can find an evaluation of every blaster and most information you want.

Thanks. Thats really helpful.

The disk shot is pretty much the same as the nitefinder internals and exterior wise.

Thank you

Some decent primaries that you can get your hands on nowadays are air tech 2000's, longshots (If modded right they can be competitive), outdoor sportsman pump shotguns, buzzbee big blasts, and big bad bows.

Thank you. Its disappointing that air techs got discontinued. But I would like to try those shotguns. I think at first glance I dismissed them as bad guns.

Big Blast are about $9, give superb ranges, and make great primaries.

Thanks

"What is best" threads are not permitted here. Making decisions for you is not the purpose of this forum.

I didn't ask what was the best or for someone to tell me what gun to get. I asked if there were other guns similar to the nite finder and I also asked other questions about the gun.

My fishing weights are BB split shots. Aren't these a lot smaller than 3/0? Also can I have a definition for a coupler? I think I know what it is but Its kind of fuzzy.

I sawed off the orange barrels but two had the inside diameter cut out more than the other two so I'll just do a single. Does the pvc on the outside of the crayola barrel add range or just accuracy. If I was not to have a two piece barrel and just a one piece what would be a good length for it. also my stock darts keep getting slits in the sides with like three pumps. Should I only use stefans. How do I make the tips softer. Is there something besides hot glue. sorry for the long post.