6 replies to this topic

[mr box]

Simple mod, really. Saw off the white barrel from the plunger and sand it so it's flush. Put the gun back together, and epoxy a 1/2" coupler to the flat front of the gun. Reinforce with hotglue and duct tape. Then it's just a SCH 80 barrel, 12" for a breech loader.

I did this over brass for 2 reasons:
-I have no darts that fit in brass
-After visiting 2 Home Depots and a Lowe's, I found no FBR of any size
-By preserving the front of the gun and the plunger tube, it is easily modded for a different, more permanent barrel later on. I'd definitely like to go telescoping brass at some point if I can find proper FBR.

Pic coming very soon, I promise.

[mr box]

Update: My darts slide well enough in the sched 80 that I can just blow them down the barrel. The barrel has been tightly pushed into the coupler and secured with duct tape.

Range testing indicates ranges of 75-85 feet. Estimated, because I don't have a bigass tape measure.

[Spoon]

Dude, you epoxied a coupler onto a flat surface? Expect this to break next war.

[mr box]

Only if I throw it.

[Spoon]

Touche. You're not getting near my guns ever again Mr. Fancy Pants.

[cxwq]

I think I'm going to leave the brass on my LnL bent and just keep loaning him the same gun.

[mr box]

Damn guys...just remember I DID offer replacement brass.