1 reply to this topic

[LukeTheZombie]

I'm having troubles plugging the release valve, not 100% sure whats going on (or if im even plugging the right thing....) Because when I close it all back up and pump, i can pump 10-15 even 100 times and it doesnt get hard to pump or bust or anything... still shoots like 25' too. I'm hot glueing that little hole at the end of the thing you pump with (the shaft that goes inside), with no success. Help =(

EDIT: Well, the O-Ring around the plunger tube was kinda stuck to the bottom on one side, letting air escape (not hot-glued, just kinda... stuck.) after 2 hours of trying I wiggled it, and it came off and ta-da it works just fine.

Edited by LukeTheZombie, 18 December 2005 - 05:14 AM.

[SupG]

Use lube like oil. It will help keep it seeld and make it work better.