6 replies to this topic

[KingCosmo7]

I need some help. I want to integrate the Longshot front gun to my Longshot, but wiring the trigger to the key ring internally confuses me. Is there any way to wire the trigger to a key ring near the main gun trigger externally? Or If not, do you know of any posts that show you step by step how to do it internally?

Thanks--
KingCosmo7

[Valdur]

I hope this helps; it's the best I could find.

http://nerfhaven.com...?showtopic=7232

[zaphodB]

yeah, there is a way to do it. Go to lowes and buy some of that thin copper pipe that bends easily, and run the string through that. you can put that pipe outside of the gun.

[AJZ]

.

Edited by AJZ, 13 July 2014 - 06:03 PM.

[Ta10n]

Or you can just skip the wire-to-keyring and make a new frontgun trigger out of plexiglas. All you need is a small sheet of plexi (a couple bucks at Homehardware or any other hardware store), superglue, and a hacksaw (and some silicone lube if you roll like that). I ran into this same problem with my LS, hence a new trigger was born: http://nerfhaven.com...showtopic=12500

(Check at the bottom of the first page for detailed internal shots of the trigger)

-Ta10n

[keef]

Well, b00m13 used Capri Sun straws to guide the wire under the magwell plates, to the trigger, but you could easily just drill a hole for it to come out through.

[PointBlankNerf222]

this should help you alot, I didnt even have to open up the gun.