cutting device
hot glue
e tape
cpvc
sandpaper
drill and a 3/16" drill bit
First take your rocketstorm
![Posted Image](http://i123.photobucket.com/albums/o305/bathburrow/eh007.jpg)
and cut off the old barrels as close to the blue pieces as possible.
![Posted Image](http://i123.photobucket.com/albums/o305/bathburrow/eh008.jpg)
Drill the holes larger in the old barrels and rough up the area with sandpaper.
![Posted Image](http://i123.photobucket.com/albums/o305/bathburrow/eh009.jpg)
Then take enough e tape to wrap around the blue piece once and cut it in half the long way.
![Posted Image](http://i123.photobucket.com/albums/o305/bathburrow/eh011.jpg)
Then cut your barrels long enough to fit a cdtd inside of it and put hot glue on the bottom of it first and then put them on over the e tape (I tried two other ways of doing this, I tried to hot glue around the base of the blue piece, I tried hot gluing when the barrels were on, and with both the other barrels get in the way) and press it hard onto the roughed up blue turret piece.
![Posted Image](http://i123.photobucket.com/albums/o305/bathburrow/eh012.jpg)
25'
44'
50'
50'
52'
52'
Total 273'
Average 45.5'
These ranges were with one rubber band.
Edited by NerfCrazy, 17 July 2008 - 08:13 PM.