
Materials Needed:
- 16mmx1.0mmx1m Aluminum Tubing (or brass)
- Duct Tape
- Hacksaw
- Hammer

Cut 24cm (9.4 inches) of aluminum and then wrap the duct tape around both ends to create a nice solid seal.

Hammer your newly created tube down the stock barrel extension barrel (sorry for the poor image)

Now to created the protruding 'seal' between the extension and the gun. Attach the barrel extension to your Recon and the lightly hammer the aluminum tubing. This will push the tubing back as far as it will go. If it protrudes too far back, the barrel won't want to connect. If it doesn't protrude enough, it is possible for the dart to catch on the newly installed barrel.

Above is an image of the perfect protrusion. This is as far as you should hammer back the aluminum (or brass)

Thats all there is to it. Simple mod that will give you a nice increase in accuracy plus adds about 5-10 feet. Finished product looks very nice. It even looks a bit like an Angel Breeched Longshot (the barrel sticking just out the front.
Edited by Frankie27, 04 July 2008 - 03:43 AM.