el swifto

Ok, so I was doing the "one pump titan" mod on my titan when I ran into a problem. When I pump it a few times, all the air leaks out. Usually the air stays in at one pump.

I'm guessing I have a leak some where along the line.


Any help here?

This thread will be devoted to information on all factors that affect a nerf "blaster"/gun's performance.

This is also applicable for modifacations.

Please contribute; the information you provide will be edited in as soon as I can get to it.

This is not just for my benefit; it is also for anyone who needs help with homemades/modding.



Thanks in advance!



*info to be edited in as we go*

ROF versus the range of your gun, plus any integrations that increase effectiveness through ROF or power.

The Basics

Spring replacement(spring gun only)
Ar removal
Barrel replacement
Plug Pump(Air gun only, not in every circumstance)

Spring info

Air Guns

psi= Pounds per Square Inch
more psi=higher velocity
more air = more power
longer barrels allow for more pressure to be built up
longer barrels= more accurate



Thanks to:
Scotch, OfAllTheNerf

Arctic Blast Super Soaker

What you're about to mod:



OK, so take about 3 inches or more of 1/2 inch sch40 pvc. Go ahead and hot glue, tape or whatever it on to the top. (see pic below)

Make note that the barrel on the Arctic blast is pointed up, so you probably want to cut/sand the pvc so its parallel to the ground.



The finished product:



I just taped mine because I ran out of hot glue. Yours will look A LOT better than mine. Dang.

And youre done! Easy, wasn't it. You can use stephans, stock darts, or for me, my titan darts.

It gets about 100 feet at 30 pumps.

Fire by pulling this top thingy.



The best part is, you can still use it as a Super Soaker!

I'm not so sure abouthow the top would work...

A couple months ago, I did oompa's titan mod.

Since I do not use or own any stephans, I was forced to use stock darts.

However, sometimes the darts did not always fire. I remedied this by wrapping 1 layer of e-tape around the dart (pics to come).

Yesterday, while fiddling around with my bbb (ARs removed and crayola'd) I found that titan darts fit in the stock bbb barrel.

I will post some ranges soon.



SO, the moral(s) this story.

If you have the same problem that I did (see third paragraph) try the methodi used.

Stock bbb barrel has a similar diameter to the 1/2 inch sch 40 pvc that Iuse.

Other than that, there really is not much of a point.

Sorry for wasting your time.


Swifto out.

I just noticed something recently.

Today, while looking through the top 10 overalll posters, I noticed that at least half of the members have not done anything or contributed ( as in no posts) . Whats up with that?

I mean, whats the point of signing up if you're not going to do anything with it? Does it make you seem cooler or more of a nerfer?

You dont even need an account to look at all the content.


I personally think that if you have an account you should actually use it.


I know its not place to judge things like this, but it makes no sense at all.



Swifto out.