ultra920

What do you use as protection?

If you chose 4, 5 or 6, post a reason.

So, i had slapped on a Crayola on my NF a while ago, and then it was getting ranges of about 50-55 feet. Now, i shot it and it went 25 feet. I checked the seals, looked at other problems people had, and even put bands, but it just doesn't shoot right.

(the barrel is a bit longer than the stock ones, and i have 1 gram weights in my darts)

Anything?(I've tried to put tape around the plunder, and it went 10 feet. I took the tape of and re-lubed it.)

I just recently got COD4 for the PS3. I was wondering if anyone else has it. My PSN is ultra920.

PS: I want to see if i can get a clan started. I'm not a expert, but i'm decent with a MP5. I don't have a headset, yet.

OK, you all should know what a Hop up is, right? For those who don't, it is on guns and is used to get the effects of angling a gun without losing accuracy. As you know, angling a blaster can cause it to be hard to aim.

All you need for this mod is a barrel that can move around a bit and a regular rubber band.

• Do a normal mod:Ar's, spring replacement, ect. When you do the barrel replacement, make sure you have a relatively thin wall so the barrel can move around.
• OK, get a rubber band. Start on the bottom of the barrel with it strait. Pull up and cross it. Now, pull it back towards the cocking handle, and set it down. make sure it isn't secures ON the cocking handle, because it may through of accuracy. Here is a rough idea of what it should look
• Now, if you did this right, the barrel will be angled. Adjust the rubber bands down so that it is perfectly strait. It should look like this:

Range comparison:

Normal flat: 53, 50, 55 Normal angled: 60,63,68

Hop up flat:49, 53, 53 Hop up angled:59(bad dart?), 65, 60



Overall, it is a simple mod that if used correctly, can be extremely effective. I tested it in a war and it is extremely effective. After some practice, i can change in about 1 second. I found it to be most effective if someone is trying to run away, or providing covering fire for your rapid fire guys.

Well, i had finally optimized my lbb, and its pretty accurate. However, the part of the trigger that pulls the pin on the tank broke. It would look like this:



1 1

1 1

---

---



Snaped right off, and i really don't want to buy another. It has a name! Anyone want to help poor little David?