Uterly
Member Since 19 Jun 2007Offline Last Active Jun 17 2008 11:59 AM
Find content
Topics I've Started
The Titan Pistol
20 July 2007 - 05:03 PM
not much of a performance mod but this drastically cuts down the size of the titan. I simply used the back end of a ball blaster to house the tank and added an extra RF 20 pump.
(it isn't screwed together in the picture but when it is it is seamless)
Inside needed a little drilling and I had to drill 2 holes for the pump and trigger pull
It is fired using the pull ring on the back but if anyone can find a way to integrate a trigger that would be sweet.
Edit: I also don't know where to attach the pump...ideas....?
(it isn't screwed together in the picture but when it is it is seamless)
Inside needed a little drilling and I had to drill 2 holes for the pump and trigger pull
It is fired using the pull ring on the back but if anyone can find a way to integrate a trigger that would be sweet.
Edit: I also don't know where to attach the pump...ideas....?
Ball Blaster Titan Integration
20 July 2007 - 02:23 AM
so I had a brain wave to try and revive my little brother's horrible ball blaster. so what more powerful than adding a titan tank!
I need more hot glue to finish up but the entire titan tank will fit inside the original handle. I can then mount the extra RF20 pump, and go for a better seal.
comments... I haven't seen this before and I doubt it will be very useful to be but it still looks bad ass
Edit: the duct tape is temporary since I ran out of hot glue
I need more hot glue to finish up but the entire titan tank will fit inside the original handle. I can then mount the extra RF20 pump, and go for a better seal.
comments... I haven't seen this before and I doubt it will be very useful to be but it still looks bad ass
Edit: the duct tape is temporary since I ran out of hot glue
