Jump to content


the nerf father

Member Since 05 May 2007
Offline Last Active Feb 18 2008 12:58 PM

Posts I've Made

In Topic: Help!

09 May 2007 - 02:45 PM

For future reference check the directory: http://nerfhaven.com...?showtopic=7150
The Firefly is a pretty weak gun because it's built around the inefficient scout style plunger.


Hey thanks for that link, its really helpful.

I do agree with you though, the FF isnt that good at all. I mostly use it because it can hold a lot of ammo(ammo that i find myself using for my NF).

I just was tired as using what would be refered to as a side weapon for my main weapon and i figured i would try to find a mod to make a good main weapon...any suggestions?

In Topic: Modding Tagger Darts For Ls

08 May 2007 - 11:03 PM

1: Yes, but you may have to shave off about 1/4" off in order for them to fit in the mav turret (and the FF, I think.)
2: Depends on the gun, and the barrel, but anywhere from 10-30 feet with most stock barrels. That vaires a lot on your dart making skills, though.


k thx man....although the only thing is for your ply to question 1...i cut that cross bar center piece outta the firefly so every dart fits in it without getting stuck.

In Topic: Modding Tagger Darts For Ls

08 May 2007 - 09:51 PM

I can give you a quick verbal, but have no pictures.

1. Clip off the top portion of the dart. (top half of the velcro head. You shouldn't be cutting foam right now.

2. peel back the remaining head, and pull it out away from the dart. This will expose a small, thin rod of plastic/rubber that goes into the foam. clip it off.

3. Now, there should be foam and what appears to be a cylinder that has a convenient BB size hole through the middle. put a bit of super glue in the hole, and stick in two BBs.(just enough so they go in)

4. Cap the dart off with a hotglue doam, or what ever your choice of tip is.



I would not use super glue - it seems over-complicated and possibly damaging to the foam. Just sitck a dab of hot glue in first, then the 2 BBs, then the hot glue dome.


Again thx, 2 questions though....1.will these darts all work normal and in all guns?....2.what are range add ons with these specific addition to the dart?

In Topic: Modding Tagger Darts For Ls

08 May 2007 - 09:16 PM

I can give you a quick verbal, but have no pictures.

1. Clip off the top portion of the dart. (top half of the velcro head. You shouldn't be cutting foam right now.

2. peel back the remaining head, and pull it out away from the dart. This will expose a small, thin rod of plastic/rubber that goes into the foam. clip it off.

3. Now, there should be foam and what appears to be a cylinder that has a convenient BB size hole through the middle. put a bit of super glue in the hole, and stick in two BBs.(just enough so they go in)

4. Cap the dart off with a hotglue doam, or what ever your choice of tip is.


Hey thanks a lot