Roschili

Hello. I am working on a school project which requires a Nerf Blaster that can be fired with a remote control. The blaster must be able to fire four times and fit in to a 12"x12"x12" box, 1 cubic foot. The Barricade and Stryfe seem like the two best options, but both are too big (14" and 14.9" respectively).

My question is this: Which of the two would be easier to cut to length? Can someone who owns one or both of them tell me if it reasonable to assume that I could cut 3" off of each blaster?

The competition will involve firing stock elite darts, but distance and accuracy aren't nearly as important as being able to fire. I have looked at pictures of the internals for both blasters, and it seems like it would be quite simple to shorten the barrel and perhaps cut off the part where the stock would attach.


Thanks!

Hi, I am trying to get my AT2K turret apart so that I can do a barrel replacement with PETG. I have looked around the forums but cannot find a good way to get the turret apart. Is it a good idea to cut the turret at the line on all four barrels or is there an easy way to get them to come out. I read that you can get them to come out by removing the small piece in between the four barrels as shown in the second picture but after removing the screw I cannot get that piece out.This is what mine looks like now. Any suggestions?





Thank you for looking.

Today I took my Magstrike apart to try to fix an air leak that it had. I think I fixed the leak but now I cannot get the gun back together because I cannot get the bladder in place. I do not want to force the bladder in because I do not want to break it. Below are some pictures of what I am trying to do. Can anyone tell me what I am doing wrong or if I am just supposed to force the white piece shown in the second picture down over the end of the bladder? Also, is the bladder just put on too far? Thanks.





I have one more question, what does everyone else use to fix air leaks?
Thanks again.

I was trying to take apart my longshot and cannot get the knobs off the sides that are used to cock the gun. Can someone explain how to get them off. I tried turning them and prying on them and neither worked. Thanks.

Ok today I got my 4-pack of eliminators in the mail and I immediately wanted to mod them to shoot my stefans but I ran into trouble taking the gun apart. I cannot get the gun apart after I took the screws out. I took all the screws out and it did not just pop apart like other guns. I tried wedging it apart with screwdrivers but I did not apply a lot of force because I did not want to break it. Here are some pictures of what it looks like. It seems to be stuck around the handle where there is like an oval shaped piece on the bottom that the extendable grip/dart holder is. I am unsure how to get the shell apart, any advice?







Ok now for my other question. I have a Buzz Bee RFR and I heard it was a good idea to reinforce the catch, can someone tell me how to do this?

Thanks everyone!