Jump to content

  2. → Viewing Profile: Posts: Exo

Exo

Member Since 14 Aug 2010
Offline Last Active Feb 12 2020 10:20 PM

Posts I've Made

In Topic: Folding Spectre stock breakdown.

29 January 2015 - 11:23 PM

Personally, I'd ATTEMPT to score a flathead line in the pin (likely using a dremel cut-off wheel) in order to get it out, that would likely damage the surrounding plastic bits the least.

Barring that, glue a dowel onto the face, and hope it holds long enough to get the screw started. If you can find a nice pan-headed screw with the same length and pitch, go ahead and throw that in there when you're done instead of this "twist rivet" thingamajig.

Also, my apologies for slow response.

In Topic: Pullback Longshot

26 January 2015 - 09:32 AM

Yeeeaaah buddy! Moddin' like it's 2009!

In Topic: Heavy Draw AAbow

16 January 2015 - 07:53 PM

Couple things:

1. Are/Why are you not worried about the copper tubing deforming?

2. What is holding the outermost bow arms in their sockets besides hope, dreams, and not-even-implied goop?

In Topic: Folding Spectre stock breakdown.

14 January 2015 - 01:17 PM

I can't seem to find a picture of this thing at all. Could you post even the most ghetto of pictures? It may end up being a screw without a head.

In Topic: Folding Spectre stock breakdown.

14 January 2015 - 10:04 AM

I think that's a driftable pin.

There's no pan on the underside, right? Like a screwhead with no visible screwhead slots? If there were one of those, then you'd need to do something crazy, like superglue a dowel to the pan and twist it out.

  1. NerfHaven
  2. → Viewing Profile: Posts: Exo
  3. Terms of Service and Privacy Policy
  4. Code of Conduct ·