Jump to content


The Irresponsible Toymaker

Member Since 12 May 2010
Offline Last Active Mar 18 2016 12:42 PM

Posts I've Made

In Topic: Buzz Bee Rogue Mod

30 November 2011 - 09:10 PM

First off, cool! I've always like how this blaster works/looks, I've always felt that this blaster is just a little bit different, which unfortunately, most N-Strike and Nerf blasters nowadays seem to lack, IMHO (They're great performance blasters, at least some of them, just that they all feel cookie-cutter-ish), but that it just hasn't gotten nearly enough love from the modding community.

However, hotglue is NOT a great way to attach stuff. Unless you put on way more than what seems to be there. Echoing ChaosPropel, epoxy would be a great idea, as, when done correctly, makes a very tough bond, as leaks are not a problem with either epoxy or hotglue.

Also, just fyi, it's the "Rogue", not the "Rouge". Rouge is what women put on their cheeks to make them look red; rogues make people red. With blood. ;)

In Topic: Pump action spectre

06 November 2011 - 09:05 AM

Cool! However, I'd suggest against using tape, as that will break VERY quickly. Maybe some screws or other mechanical fasteners? Epoxy/hot glue would NOT be good for this type of adhesion, just warning you. Very cool and innovative! And welcome to the Haven!

In Topic: Shorty Maverick

25 October 2011 - 05:20 PM

First off, very nice, clean mod. However, to echo SonReeceSonJensen, what exactly is the point? Are the ranges better? I get how it would work better with stefans due to the easier reload, but I don't see how it would affect performance...maybe I'm missing something. At any rate, very nice mod and write up, looks near stock.

In Topic: Need help locating where I can get a spring for the Bullet Guard for t

13 October 2011 - 05:51 PM

At the risk of overstepping my limits, I BELIEVE that what Exo was trying to say was that

If you adjust the DIAMETER of the spring peg, then the pen spring will fit.



You, Juggernaut, I BELIEVE misinterpreted this as shaving down the entirety of the dart tooth. This would be unnecessary and yes, could weaken the blaster. However, I believe that the peg which the spring goes on and which Exo is referring to (apologies for no image, couldn't find one suitable) could be trimmed without

weaken[ing] the darth tooth

, which would allow a spring of smaller diameter to be used, since the peg itself, from my basic knowledge of physics, is not under significant or even noticeable stress.

If I have misinterpreted either of your words, I'd like to apologize; I'm just trying to help clear this up. Hope this helps!

In Topic: Octo-Shot

30 April 2011 - 04:06 PM

I second Chadpuff's suggestion.

It sounds like people have been making these. Have any of you ever tried shotgun loading it, and if so, how did it work? I was wondering just for comparison to the other overhaul which gets a lower range and only has 4 shots but keeps the shotgun spread, which I personally enjoy.