mrgamersco

required

1/2in cpvc
3/4in pex
1/2in hollow aluminum rod
1/2in cpvc couplers
3/4x3/4x1/2in CPVC reducing TEE
hotglue
saw

excuse my video editing capabilities... I learn quick but not quick enough for this build.

heres the basics Click on the pictures to make them larger.



I ran a 3/4in drill bit into the tee to make room for the 3/4in PEX pipe, this is just to reduce deadspace inside the tee..



you can see a 5/8in long piece of 1/2in cpvc sticking out the small end of it, deburred and smoothed on the inside. Tee is hotglue to end of LS plunger tube making airtight seal.



1ft long piece of 1/2in hollow aluminum tube installed into longshot priming thingamajig. I used a piece of 1/2in long 1/2in cpvc and some etape to make sure it was centered and then hotglued the bajezus out of it all.



side pic. stock Longshot piece, 1.5in piece of cpvc, aluminum rod and oring. If you look back to the first pic you can see where the hole needs to be. the rest of the piece of aluminum rod is plugged off with hotglue blocking air from coming out the front of it. you will have to fiddle with the length of the cpvc to get a seal between the oring and the chamfered surface inside the cpvc reducing tee.



here is the assembly inside the LS shell (or whats left of an LS shell)




nother angle