Find contentRequirements,
1 Dremel
Dremel drill and Grinding Tips
At2k Internals
Disc-Shot Shell
1 Coupler of your barrel of choice. ( Mine's cpvc )
Some Sort of Steel wire. ( The kind you would use to hang a picture on the wall )
And Hot-Glue, Lots of Hot-Glue
So here's what I did,
First of all open up your gun,
I had a shell lying around that I had gutted.
After you have the gun open take out all of the stock gun parts.
Then take your 2k and take out the internals. You only need these two parts,
Set those aside, you will need them later.
Then take your Disc-Shot shell and Drill holes on both sides here,
And Here,
Then take your 2k parts and Lay them in the Disc-Shot shell like so,
( This Picture was taken after the gun was finished )
Close the shell to make sure everything fits. If it dosen't, use a grinding wheel on your dremel, and grind out what ever it is thats blocking a part.
After everything fits in your shell, You will notice that the pump is a little to long so,
Cut Both the pump handle and the pump tube on that black mark.
After thats done take the part you cut off of the pump handle cut it down so there barely any white plastic sticking out then glue the two pieces back together. Like so,
Once thats done make sure with out a doubt that the at2k part of the gun works. If it does, glue the parts down. Then take that steel wire and wrap it around the thing you pull to fire the 2k, and glue it on. Run the wire though the hole where the priming handle used to be. Close the gun up and Ta-Da, Your done.
It should look like this when finished,
The gun gets an estimated 100 feet, with ten pumps. I would measure exactly but, I don't have one of those really long measuring tape things.
And that's it. Any Questions, Comments, Flames ?
P.S Wish me luck in the contest.
Edit: Okay I wired up the trigger, and It works up to five pumps. Any above that and the pressure is too great for it to pull.
