Jump to content


idk59

Member Since 16 Dec 2008
Offline Last Active Oct 24 2010 05:08 PM

Posts I've Made

In Topic: Ball Valve

09 July 2009 - 12:11 AM

Most 1/2 inch CPVC ball valves are hard to open. I changed it to a brass ball valve with some seal tape on the CPVC to keep it both air tight and stuck on there so it won't pop out.

By the way, most PVC ball valves are easy to open. It's just the CPVC's.

In Topic: Trimav

01 July 2009 - 12:03 AM

That thing would own if you made it a Nite- Mav.
Would be a handy secondary at wars.
Other wise, nice job like usual. :D

In Topic: Sspb Write-up

29 June 2009 - 01:08 AM

Nice job although this has been done before. Ranges?

In Topic: Snappy

25 May 2009 - 12:53 AM

I have cut off the pinty part of the nail so itwon't cut anything but the nail does go in front of the plunger head.

In Topic: Where To Buy Modding Materials

11 May 2009 - 08:25 PM

Do they sell brass at Home Depot or Lowes?
When I always go to Lowes, they only have copper there.

Is copper a good barreling material?