Jump to content


VBUser

Member Since 21 May 2003
Offline Last Active May 23 2003 08:49 PM

Posts I've Made

In Topic: Advice For An Airsofter

22 May 2003 - 05:44 PM

Thanks for the help! Always nice to find admins who look out for the noobs!

And now, to raid my Toys 'R' Us!

...Plus Home Depot for foam, and the local Airsoft shop, Tactical Air, for some more BB's.

In Topic: First Shot

22 May 2003 - 03:36 AM

This is my first mod ever (:D), using a RoseArt marker--the same as Black Cat advises.

Take the RoseArt marker (the big kind) apart with plyers, removing all internal parts. Take a hacksaw, and take off the tip. Saw right below the lip, right as the smaller part begins. You'll be left with a white tube--the end you sawed off will be smaller. Take apart your FirstShot, and look at the barrel. There's a blue piece on the end, take it off with some plyers. Slip the small end of your marker over the post, then duct tape it in place. Use a lot of duct tape, and make sure it's airtight. You're ready to go (after an easy reassembly).

Also, use black electrical tape to make the part of the marker that extends out more pretty. Make it thick right at the base, so the black piece that comes with the gun fits snugly over it.

For a more perminent mod, use a glue gun to seal up the junction between marker and post.

This fits Nerf Micros and...I havn't made any of my own darts yet. The inner barrel diameter of a marker is about 1/2 inch, FYI.