imperious

I got a RF20 for $2.00 but it was broken so i did this.

Parts
3/4 cpvc
1/2 cpvc
3/4 to 1/2 cpvc coupler


Remove this part.


Cut a piece of 3/4 cpvc and glue it in place.


This will replace the black part that was taken off.

The 3/4 cpvc should stick out like this.


Put on the 3/4 to 1/2 cpvc coupler.


Cut a 12in. 1/2 cpvc barrel.


Cut a small piece of cpvc to keep this part pushed down.


New mods

I took e-tape wrapped it around under the o-ring.

Then cut the e-tape so it fits.



Now add a rubber band on this part.

put the rubber band on this.


Finished


To load the gun remove barrel and put the dart in the 3/4 cpvc. This must be done to get best range.

For the single shot 10 pumps.

The rannge is 50-60.

Parts- PVC, CPVC, PVC and CPVC couplers, PVC T coupler, PVC cap.

Cut a CPVC coupler and put it in a PVC coupler.



Cut the PVC and put on the coupler you made.


Now take a PVC T coupler and cap it off. You can use a normal coupler for this but i was out



Cut a small part of CPVC and put a coupler on it and put in the T coupler.



Put the PVC on the T coupler.


Cut a CPVC barrel.


Finshed



The gun must be primed down to keep the dart from being pulled in the plunger tube.

A vid of it

Minimized long shot the ms-1

Start by cutting the gun like this.


Put a pvc to cpvc coupler in the plunger tube and add foam and springs to the plunger rod.




Then put a wire on the plunger rod and add a keyring.




Cut the gun here then put parts in place.




Now reassemble the gun.






Its hiting 80-90ft.

Tell me if i misspelled.