soccerbeast003

I'm having trouble figuring out how to solve this. I have an almost airtight seal, but I will have one if I can have a force pushing against it, such as a bracket like AssassinNF did. So my question is, how can I go about this without destroying too much of the shell?

Ok, I don't think pictures are needed here, but if needed I will post them.
Whenver I prime it, the rotation mech moves the half of turn it should, but when it returns it doesn't move it the other half it needs to, it puts it back in it's original position.

Anyone know how I can fix it?

I'll get straight to the point. Whenever the shell is closed, I have to pump it really fast to keep pressure in. Otherwise, it just escapes out the barrel. If the shell is open, it pumps perfectly fine. I've tried spraying silicone spray in it and no luck.
For reference, I'm using a magstrike pump.

Hello all. I have stumbled upon a new idea.

Materials:
Cpvc
About an inch and a half of a titan pump tube
3/4 Cpvc
The bottom stock of a longshot stock.
Patience

First, cut a breech slot as wide as the clip, and hammer in your stub of Titan pump tube to the 3/4 cpvc. The breech slot bottom where to dart falls on needs to be 1/4 of an inch. Note: The bottom part of the slot here is NOT 1/4 inch, but it needs to be.


Here's what it should look like:

Then cut your stock like so:


Next, glue your Stock Butt on your cut breech. Note: when the clip is in, it needs to line up with the bottom of the slot cut

And wrap your cpvc in electrical tape to have snug/loose fit in the 3/4 cpvc.
You can also attach a string so whenever you open your breech your barrel does not fall out.
And now you can attach it on any cpvc coupler!
Video:
Update: The clip fits the drum mag and it is very sturdy, but bulky.


Questions or Comments? Anything unclear?

Hello all, I have a new mod that I haven’t seen yet.
So first open up your gun.
And cut down your 3k tank like this:

And glue on a cpvc coupler and stick a piece of cpvc in it.

Sorry, no picture for this next step. You need to glue on a rubber washer to make a good seal with your turret.
Then you need to rebarrel the turret however you want to do it, I personally used cpvc.
Now you need to cut down these parts.


Now glue your tank in like so and drill a hole where your tubing will feed through.

Note you need to take out the white part that rotates the turret.
Now attach a metal wire to the tank pin and feed it through your trigger opening.


And attach your pump like so. Now just coupler your big blast part and your done!


Note: With this mod you need to manually rotate the turret.