Find content
this is a writeup explaining how to integrate a pocket blaster with a tech shot
materials:
3" cpvc
tech shot
pocket blaster
tools: (required)
saw
Philips head screw driver
drill
tools:(not required but helpful)
dremel
sandpaper
hot glue gun
1. remove all the screws holding the pocket blaster closed
2. cut the end off the barrel off the pocket blaster and drill out the peg the dart sits on.
3.make the following cuts on the tech shots shell, this is where the barrel of the pocket blaster will be
4.open the tech shot and pull out the barrel and plunger assembly
5. the barrel should pull right off from the plunger tube,then slide the cpvc over where the barrel used to be, it should fit perfectly glue it on if you want.
6. replace the plunger and barrel assembly and make these cuts to the inside of both sides of the shells,
when cutting the hole for the pocket blasters trigger only cut out the bottom of the shell
the pic wouldn't work so here is a link
7 place the pocket blaster in the area that used to hold extra darts, glue it in if it moves around too much.
8. close the case and put the screws back in.
tada! a fully modified and integrated tech shot
ranges:
tech TARGET 50FT
pocket blaster ?
(it is possible to mod and integrate these guns using only a saw and a screwdriver)
