mocky

For all Sydney siders, vulcans are in stock at TRU Parramatta and currently are on special for $60.

Thanks, so stretching the lips on the mag doesn't damage to the clips on a long term. I under if you cut it too thin it'll be flimsy, and not enough of a arc to center the dart as it feeds through. But why can't it be slightly less than a half pipe? ( by 'less' half-pipe I don't mean a shorter length of half-pipe, I mean reduce the arc length of the cut out section)
I thought the breech works like this.
Closed 19/32
Insert clip
Draw back bolt, 19/32"+17/32"+1/2" brass draws back
Dart from clip pushes up against 9/16" receiver
Bolt forward, 1/2" pushes dart into 9/16" brass with tightening ring and 19/32" closes breech.

Besides that, I think all my questioned were thoroughly answered ty.

I've got all this 1/2" K&S brass I bought since I was given the impression it could be used as a barrel material, it was also more available than the other sizes of K&S brass. I can push a tagger about 15mm in 1/2" brass before it buckles. Since I've measured tagger sizes with calipers, I take it that you guys must heatgun your foam or compress it to get it to fit.
Nice writeup for those who use 1/2" barrel too bad it doesn't take larger sized barrels. Are there accurate measurement of ranges for this mod yet?

Nice mod, I've seen something similar using a plunger tube cut in half, but this is definitely a lot cleaner and the best part is the mod is reversible.

Wait a sec, how are you getting CDTS's to shoot out of 1/2" brass?

its pretty much a stefan made with the foam of a tagger dart. it fits just fine.

1/2" brass is the outer diameter of the brass tube, so if a tagger is 1/2" in diameter how is meant to fit into a hole with a diameter less than 1/2"?

Also in Angel's breech mod he explicitly states the 1/2" brass is to push the dart forward from the breech into the 19/32" brass barrel (with tightenging rings). I have 30 taggers and 3 x 12" lengths of 1/2" brass tube and none of them fit, actually none of my darts will fit 1/2" brass tube, even my 10mm FBR won't slide into a 1/2" brass tube. Using vernier calipers, foam from regular 30pack of nerf dart taggers are 0.4830" and I.D. of 1/2" brass is 0.4710". Explain yourself.