Jump to content


rylundo

Member Since 30 Jun 2005
Offline Last Active Sep 25 2006 12:37 PM

Topics I've Started

New Hampshire

20 January 2006 - 06:20 PM

My parents want me to go to a boarding school in New Hampshire :( . They're pretty serious about it because me an my mom are flying down to check it out this weekend. Hopefully i won't have to go but to get to the point, any nerfers up there?

At2k Problem

24 August 2005 - 04:08 PM

I am not really sure where to put this so i am putting it in general nerf. Ok now on to the topic. I put a new pump shaft and handle in my at2k and there is pressure when i pump but no matter how much i pump it has the pressure of one pump before i replaced it. Does any one know what is causing this and how to fix it?

N-strike Unity System

12 August 2005 - 07:29 PM

Rylundo...the poll creator.

Maverick Problem

16 July 2005 - 04:02 PM

Two days ago my maverick broke. The small piece of plastic on part of the plunger assembely that pulls back the plunger when you cock it because that little metal bar pushes it back snapped into multiple pieces. Has anyone else had this problem?

Modified Secret Shot

30 June 2005 - 04:53 PM

I modified my secret shot to act as a warthog and it can fire each bullet indivdually also. I will post pictures once i get around to it.

take out all the screws.

rip the little tube thing out of the orange thing that you stick that dart on that was from the handle of the gun. since most of the dohickeys are orange i will refer to this one as orange thingey number 1 and the tube as little tuby thing.( sorry im not very discreptive). on the other end of the tube is yep you geussed it orange thingey number 2.leave that part alone for now. next to it is a big orange tube with three dents in them the top one punched out.with a screwdriver make a hole in the BOTTOM LEFT dent.( if you didnot catch the capital letters its because that parts is important) now make a hole in the front of the gun down and to the right of the hole already there, make it big enough to fit a dart into.now lay orange thingey number 1 in the hole you just created the make the tube the coreect length to reach (you have to cut the tube). then glue the tube in place and glue orange thingey number 1 into place ( i used a hot glue gun). close it up put the screws back in and your ready to go.
:ph34r: WARNING :blink:

IF YOU ARE CONFUSED IN ANY WAY DO NOT DO ANY OF THE ABOVE PROCEDURES UNTILL I POST PICTURES WICH WILL MAKE EVERY THING MAKE MORE SENSE.