- NerfHaven
- → Viewing Profile: Posts: Eleven11punk
Eleven11punk
Member Since 18 Dec 2019Offline Last Active Feb 23 2020 04:47 PM
Community Stats
- Group Members
- Active Posts 9
- Profile Views 3,159
- Member Title Member
- Age Age Unknown
- Birthday Birthday Unknown
User Tools
Latest Visitors
No latest visitors to show
Posts I've Made
In Topic: Ballzooka 94 mod
21 February 2020 - 01:30 PM
However there was no noticable difference for me in range..haha oh well. I may mess with it some more; try to get a better seal where the white tube meets the barrels. It was fun for my first nerf mod. If I ever do the barrel extension I'll be sure to post it in mods section. Thanks again!
In Topic: Ballzooka 94 mod
30 January 2020 - 11:50 AM
You don't put any on the back. You put one in the middle that matches the ID of the skirt seal (7/8") so it stays put, and you put one on the front that's just large enough (1 1/4") to hold the skirt on.
Did you use a hole saw to cut the poly? I was planning on using one but not sure if the center drill bit part would be larger than the 9/64 hole you said to drill for the screw.
In Topic: Ballzooka 94 mod
27 January 2020 - 07:24 PM
In Topic: Ballzooka 94 mod
24 January 2020 - 09:07 PM
The only mod writeup I've ever seen for that blaster is the one I did. I'm not sure it's a great mod, but it exists.
To answer your questions, it's a manual plunger blaster, sometimes called "push-pull" blaster, for obvious reasons. Lately I've seen this style of blaster called HAMPs, after Kane's blaster of that name. I'm not sure about extending the inline clips. I've never seen it done.
Hey so I ordered the rubber seal but reading over your instructions for the polycarbonate I'm a little confused.
Are there two pieces I should cut? (One for front and back?)
In Topic: Ballzooka 94 mod
24 January 2020 - 12:13 PM
Click "Image Archive" at the top right. They were a victim of the imageshack apocalypse a few years ago, but survive in that archive.
Great! I couldn't see it because I wasn't on fullsite mode. Okay so now I just need to find another cheap, available ballzooka. A broken one I can part out.
- NerfHaven
- → Viewing Profile: Posts: Eleven11punk
- Terms of Service and Privacy Policy
- Code of Conduct ·