Jump to content


mason

Member Since 16 Mar 2003
Offline Last Active May 27 2003 10:22 PM

Topics I've Started

Petg Tubing In Eab

13 April 2003 - 06:24 PM

I have copper right now, and it's good, but i have to have the perfect fitting dart to get like 75 feet, which means i have to tape them perfectly (they have to be zero darts to fit really well) and i was thinking about using PETG since it has similar performance and fitting to brass. Would this work well, cause I'd like to try it.

Eab Replacement Spring Not Working

13 April 2003 - 04:54 PM

the one I got is too powerful so when I pull back it doesn't catch on the catching mechanism, it just goes back. so do you know what model CXWQ used for his replacement spring was or do you know a model of a good replacement spring for the eab

Eab Spring Replacement

13 April 2003 - 04:02 PM

CXWQ what did you use to cut your replacement spring

Cutting Petg

13 April 2003 - 12:14 PM

ok, I CAN cut it with a hacksaw, it is pretty hard to get a good straight cut though, because it seems like its pretty hard to work with, i also tried using a pipe cutter and that just smashed the PETG, so what is the best way to cut PETG

Copper Or Brass

13 April 2003 - 10:47 AM

Well, i've been using copper for a lot of my mods, and it seems like it does a pretty good job, but is brass really a lot better. My reasons for getting copper 1. i can't find brass 2. its a lot cheaper. 3. It seems like it works pretty well. 4. well to tell you the truth i think copper looks pretty cool. So, is brass better than copper, is copper as good as brass, will copper give you similar performance, or is brass far superior to copper. O, and isn't PETG tubing as good as brass, I think that's what CXWQ said.