MOD it

I think I might do this mod. I want to do a Night-mav to an cant decide which.

Don't try stretching your springs just yet. What type of barrel material are you using? If it is CPVC, then there is a LOT of friction, so it is really hard for the dart to leave the barrel, as for brass, aluminum, and copper, they all have low friction, so you can shove the dart way down into the barrel. You can do the same for 1/2 inch PVC, but it is'nt very good for stefans.

I used epoxy on it and yes its cpvc. The gun really isn't old, maybe a few months and I already checked the seal,its not that.

I just got a crossfire yesterday and i was wondering how you get the air restrictor out- without a drill or dremel? Also, should I add a maverick spring to it or will that damage the thing that holds the pin? Thanks.

If you add another spring from a mav and it does break that piece then you could just use a zip tie and as for gettin the ar out without a dremel, probably not gonna happen it took me a couple hours to WITH a dremel. So my advice would be stop being cheap and go get one! They really are great tools to have and you will be much happier once you have one.

Try adding punctuation and maybe you might help a little.

Bend over and put your head between your legs. Then firmly shove it in your ass and SHUT UP!!

I just got a crossfire yesterday and i was wondering how you get the air restrictor out- without a drill or dremel? Also, should I add a maverick spring to it or will that damage the thing that holds the pin? Thanks.

If you add another spring from a mav and it does break that piece then you could just use a zip tie and as for gettin the ar out without a dremel, probably not gonna happen it took me a couple hours to WITH a dremel. So my advice would be stop being cheap and go get one! They really are great tools to have and you will be much happier once you have one.

Im getting close to finishing mine and will hopefully post pics when its all done.