Jump to content


Blasterthinktank

Member Since 28 Jan 2017
Offline Last Active Feb 01 2017 02:15 AM

Posts I've Made

In Topic: Alphahawk prime

01 February 2017 - 02:19 AM

Best way in my opinion is to jam something hard and thin into the gap right above the priming handle. I used the flathead screwdriver on my leatherman tool. The tool will be pressing up the small tab that locks the handle, so you need to be wiggling the handle out while pressing the tool in. Be careful not to end up jabbing yourself in the hand like I did. With a little patience and some brute force the handles will come out. Once they're out, you can shave a little bit of the plastic off the handle and it will be removeable in the future much easier.