Jump to content

  2. → Viewing Profile: Topics: Mattakers

Mattakers

Member Since 26 Apr 2015
Offline Last Active Apr 12 2016 07:21 PM

Topics I've Started

Rampage breech

06 July 2015 - 05:15 PM

Hey NerfHaven! So when I was drilling out my rampage's air restrictor I accidently damaged a bit of the breech. Though it actually didn't affect performance at all, this got me thinking about making a new breech for it. I want it to still be mag fed and shoot elites. Has anyone tried making a new breech for a rampage? If so, can you give me any suggestions or tips?

Thanks,
Mattakers

Extreme air max one modification questions

04 June 2015 - 04:19 PM

So I bought an extreme air max one a couple of days ago, and I want to make a brass breech for it. I want to know if I use a 3/4" to 1/2" pvc reducer, will it be air tight with 9/16" brass pipe? Here is the reducer and here is the brass pipe if it makes a difference. As an inner barrel, I wanted to use this. Is this an effective barrel setup? Is there anything I'm doing wrong?
Thanks a lot,
Mattakers

AC charger for a lipo battery

14 May 2015 - 04:50 PM

Hi! I want to get this this LiPo battery. Can someone recommend a AC charger/balancer for it?

Stryfe mods

09 May 2015 - 01:25 PM

So, I've decided to modify a stryfe instead of a demolisher. I went to a hobby store to look at LiPo's, but the owner of the store said I should use a Nickel-Metal Hydride battery. I looked into it, and I found a 6 cell NiMH battery has almost the same voltage as a 2 cell LiPO. Which one would you recommend? What is a good AC charger for a NiMH battery? I wanted to use these motors. Can a 6 cell NiMH battery power that? What kind of range should I expect? Does the shell need to be modified to fit the new motors? What is a good replacement switch for the rev trigger? Thanks for helping!

Demolisher motor replacement, rewiring, and lipo battery

29 April 2015 - 04:52 PM

Hi! I want to start my first mod on a flywheel blaster. I have chosen the demolisher 2 in 1 to mod. I was thinking of replacing the motors with xtreme 180's and using a Venom 20C 3S 2100mAh 11.1v LiPO Battery. Is this battery good for xtreme 180's? If so, could you recommend a good charger for the LiPo? I have also heard that I will need to modify the shell to fit the new motors. How exactly do I do that? I was also planning to rewire the gun to bypass the electronic locks, thermistors and resistors. Do you have any advice on that?

Thanks so much for helping,
Mattakers

  1. NerfHaven
  2. → Viewing Profile: Topics: Mattakers
  3. Terms of Service and Privacy Policy
  4. Code of Conduct ·