Jump to content


Member Since 17 May 2012
Offline Last Active Sep 09 2012 06:51 PM

Topics I've Started

Air Gun trigger spring

25 June 2012 - 04:21 PM

Ok so today I opened up my at3k to replace the pump with my hydro cannon pump. I gutted everything on the pump including the trigger. I took the trigger spring off and set it aside. So when i figured out the pump didn't work I started putting the the trigger on without the trigger spring. When I finished closing up the gun I pulled the trigger and noticed is was signifecantly easier and smoother to pull and in my confusion I happened to glance over and see the trigger spring laying out. So I thought it still might fire and sure enough it did! And when I had the gun pumped up I could feel the trigger pull was MUCH EASIER to fire than with the installed trigger spring. In the trigger's rest position it didn't slide around cause if assembled correctly the at3k's trigger actually raps around the firing pin in between to walls. And when the gun is fired the firing pin shoots foward back to the front of the tank with the trigger on it so it also acts as a return spring. So taking out the trigger spring in a 1k, 2k, 3k, 4k, and supermaxx 1500 and 3000 etc would work. So I was wondering how you would like it, so if you have have anyone of these guns I would highly reccomend trying it out becuase I think it makes the trigger pull much smoother. So if you did I would like to see what you think of it below if you have the time. Thank You for your time! BMSC