Foam of Grianter

What do you mean? The turret cannot fall off because of the end-cap at the end of the turret support rod. Also, the turret is held in place by the dart tube that is used at the time. To elaborate; were the dart tube is connected to the coupler. The turret seems like it is quite strong, the gun is the part I would worry about.

I'm guessing it's quite heavy. So, having something to support the back part of the turret would help. Otherwise the torque may break or detach something.

Hmmm... It's kinda weird how Hasbro didn't classify this as an ECS gun... I mean if the Barricade is an RV instead of REV this should be ECS instead of Cs

Daniel Beaver: Oh I see, I guess the straw was too tight.

And thanks for the tip.

nerfnut23: I understand what you mean. You're probably right. Since air pressure goes in all directions it also slows down my plunger. That mean less air flow.

I was planning to Angel Breech the stampede. 6" sound good for a barrel. I was thinking of trying 10" to 2" barrels. I wanted to make 2 very minimized stampedes with short barrels, and 2 slightly minimized stampedes with 7" to 5" (depending what's most suitable) barrels.

And sorry for my bad English. I will try to fix that from here on out. Thanks for the heads up.

SgNerf: Oh okay I get it now. I will probably go with 9/16" brass because of my dart tips/ Although I will probably go with aluminum with 0.51" or 0.527" ID because I can't find any brass.

Yeah the straw is too thin. I was dispensing silicone into Nerf streamline tips a few weeks ago. I noticed that with a thinner dispenser silicone was dispensed at a slower rate and the velocity they came out at was slower as well.

Wow, darts are getting stuck in longer barrels. Thanks for the info. Now I won't be spending time trying that. I only own a Recon and Stampede(they are both broken). I'll probably make a 3" barrel for the Recon. It's a nice manual, clip system sidearm.

P.S. you're one of my favorite modders. I'm going to get a Longshot sometime this week. I'm going to do your Polycarbonate shotgun grip mod, except with Plexiglass.

Exo: Oh I've never seen the PETG version. I was going to use steel/Aluminum/CPVC because I couldn't find local stores with Brass.

I've never heard of a wye. I've heard of RSCB but I'm not completely sure what it is.

Everyone in General: I'm going to be doing an Aluminum Angel Breech on a Longshot sooner or later.

I've already come up with the blueprints for a blot lock mech on the stampede. If I ever get a new stampede, I may make a write-up.

If I get a new Recon (or a replacement plunger and sled on my old one) I'll try to make a Angel Breech for it. I may try to make it Semi-Auto as well. I've come u with the blueprints for the mechanics and electronics already. I'm not sure if I'll go through with that thoguh. A minimized stampede seems better.