Juggernaut
Member Since 13 Sep 2011Offline Last Active Nov 22 2015 04:07 PM
Find content
Topics I've Started
Need help locating where I can get a spring for the Bullet Guard for t
11 October 2011 - 06:20 PM
I recently Took out the Bullet Guard to see how My Nerf Recon would shoot. I didn't like the results. So I was going to put the Bullet guard back but I lost the spring. ( I will post a picture in a few minutes). I tried pen springs because that is what I usually use if I loose a spring of that size but there diameter were to small. So does anyone know if they even sell those type of spring dosen't have to be made for the recon. I just need a spring that will fit and do its job and I have a wire cutter in case it is too long.
The spring in the red square is the spring I need
The spring in the red square is the spring I need
Me fully Armed with my Modded Nerf Equipment
11 October 2011 - 04:54 PM
That is me with my Modded Recon I removed the Air compression chamber and replaced the plunger with an Aluminum one. I also replaced its normal clip with a Stampede clip. And I have my Tactical Vest fully decked out with Full Clips and Bullets. And Across my chest is the Ammo belt clip full with bullets and an extra clip. And in then there is my Modded nite finder in the holdster
