Beasty Billy

I think it was established the last time someone found a security issue that the standard operating policy when a potential security issue is discovered is to PM the admins, not to post it. The last time, it was replicable, but there's nothing to say it isn't this time as well.

If you haven't PMed Langley, please do so now.

Yes, that was my post and Langley said to PM any admin ASAP.

Sometimes with stock darts, more power can make them get worse ranges. Are the darts spinning out or flying straight? If they are flying straight, the above suggestions are probably true.

I am planning to buy new pistols and i need to know which ones are better. Scout or Nite finder? And do you guys know if there is a attachable barrel that can be placed right into the barrel of the guns? i just need to know if there is a barrel that i can just stick right into hole without making any cuttings. Also, will a handsaw saw through a brass tube? if not, how do i but a brass tube?

You will get much better ranges from a NiteFinder. A well modded NiteFinder can hit ranges of about 60-70 feet flat. Scouts are reverse plunger, so have much less power and potential. The only barrel materal that might fit in a stock barrel is 17/32 brass. I am not sure though because I have never tried and have no brass at hand. And if by a hand saw you mean a hacksaw, you should have no trouble sawing through brass. However, be sure to sand down the cut so your darts dont get damaged. I hope I helped in some way.

I recently Took out the Bullet Guard to see how My Nerf Recon would shoot. I didn't like the results. So I was going to put the Bullet guard back but I lost the spring. ( I will post a picture in a few minutes). I tried pen springs because that is what I usually use if I loose a spring of that size but there diameter were to small. So does anyone know if they even sell those type of spring dosen't have to be made for the recon. I just need a spring that will fit and do its job and I have a wire cutter in case it is too long.

By bullet guard, do you mean the dart tooth? And as stated before, your local Home Depot or Lowes probably have one.

Ahh I see. Thanks for explaining.